top of page

Interbond 201 Temperate

 

Product Description

 

A hard wearing, surface tolerant, two pack epoxy primer/finish offering corrosion protection in one coat. A low temperature version of Interbond 201 is available for use down to -5°C.

 

 

Intended Uses

As an anticorrosive primer/finish for decks, deck fittings and cargo holds. For use at Maintenance & Repair or On Board Maintenance.

Product Information

Colour: Signal Green, Red, Storm Grey, Surf Grey

Finish/Sheen: Semi-gloss

Sizes:

Part B (Curing Agent): KDA100 (temperate)

Volume Solids: 74%±2% (ISO 3233:1998)

Mix Ratio: 4.00 volume(s) Part A to 1 volume(s) Part B

Typical Film Thickness:150 microns dry (203 microns wet)

Theoretical Coverage: 4.93 m²/litre at 150 microns dft, allow appropriate loss factors

Method of Application: Airless Spray, Brush, Roller
Flash Point (Typical): Part A 28°C;Part B 34°C;Mixed 29°C (Product produced and supplied in North America has flash points of Part A 43°C , Part B 39°C and Mixed 39°C respectively due to locally sourced solvents. There is no detrimental effect on product performance.)

Induction Period: 30 minutes at temperatures below 25°C for KDA100

Thinner

 

Thinning is not normally required for Interbond 201 Temperate.

If required use nternational GTA220.

 

 

Technical Data Sheet

bottom of page