top of page

Intergard 263

Product Description

A two pack, tar free, epoxy tie coat.

Intended Uses

As a tie coat between anticorrosives and either antifoulings or cosmetic finishes to ensure maximum system adhesion and performance on outside shell vessel areas.

 

As a sealer coat over Tributyltin (TBT) antifoulings.

 

For use at Newbuilding, Maintenance & Repair or On Board Maintenance.

Product Information

Colours: Light Grey

Finish/Sheen: Matt

Sizes: 20L

Part B (Curing Agent): FAA262

Volume Solids: 57% ±2% (ISO 3233:1998)

Mix Ratio: 4 volume(s) Part A to 1 volume(s) Part B

Typical Film Thickness: 100 microns dry (175 microns wet)

Theoretical Coverage: 5.7 m²/litre at 100 microns dft, allow appropriate loss factors

Method of Application: Airless Spray, Brush, Roller

Flash Point (Typical) Part A 45°C; Part B 21°C; Mixed 38°C

Induction Period Not required

Thinner

Thinning is not normally required for Intergard 263.

If required use International GTA220.

Technical Data Sheet

bottom of page