Intergard 269

​

Product Description

​

A quick drying two pack epoxy holding primer / tie coat which is suitable for overcoating after extended periods of weathering.

​

​

Intended Uses

​

For use as a primer for the protection of prepared steel prior to the application of a wide range of products.

 

Can also be used as a tie coat for application to freshly applied zinc primers to prevent zinc salt formation on weathering and to reduce pinholing of subsequent applied coatings.

 

Suitable for use with controlled cathodic protection. For use at Newbuilding, Maintenance & Repair or On Board Maintenance.

​

​

Product Information

​

Colours: Red

Finish/Sheen: Not applicable

Sizes: 20L

​

Part B (Curing Agent): EGA089

Volume Solids: 47% ±2% (ISO 3233:1998)

Typical Film Thickness: 40 microns dry (85 microns wet)

Theoretical Coverage: 11.75 m²/litre at 40 microns dft, allow appropriate loss factors

Method of Application: Airless Spray, Brush, Conventional Spray, Roller 

Flash Point (Typical): Part A 26°C; Part B 25°C; Mixed 26°C

Induction Period: Not required

​

​

Thinner

​

Thinning is not normally required for Intergard 269.

If required use International GTA220.

​

​

Technical Data Sheet

​

​

​

​