top of page

Intergard 400

 

Product Description

 

A two pack epoxy abrasion resistant coating, containing micaceous iron oxide, which can be overcoated after extended periods.

Intended Uses

As a general purpose primer for all non-permanently immersed areas. For use at Newbuilding.

 

 

Product Information

Colours: Dark Grey and Light Grey

Finish/Sheen: Not applicable

Sizes: 


Part B (Curing Agent): EPA740

Volume Solids: 65% ±2% (ISO 3233:1998)
Mix Ratio: 5.67 volume(s) Part A to 1 volume(s) Part B

Typical Film Thickness: 125 microns dry (192 microns wet)
Theoretical Coverage: 5.2 m²/litre at 125 microns dft, allow appropriate loss factors
Method of Application: Airless Spray, Roller, Brush
Flash Point (Typical): Part A 23°C; Part B 23°C; Mixed 25°C
Induction Period: 30 minutes at temperatures below 25°C

 

 

Thinner

 

Thinning is not normally required for Intergard 400.

If required use International GTA220.

 

 

Technical Data Sheet

bottom of page