top of page

Intershield 300

Product Description

A light coloured, abrasion resistant, aluminium pure epoxy coating giving excellent long term anticorrosive protection and low temperature application capability.



Intended Uses

A universal primer which can be applied directly to mechanically prepared shop primer or suitably prepared bare steel.


Suitable for use with controlled cathodic protection. For use at Newbuilding or Maintenance & Repair.


Product Information

Colour: Bronze and Aluminium

Finish/Sheen: Not applicable

Sizes: 20L

Part B (Curing Agent): ENA303

Volume Solids: 60% ±2% (ISO 3233:1998)

Mix Ratio: 2.50 volume(s) Part A to 1 volume(s) Part B

Typical Film Thickness: 125 microns dry (208 microns wet). Range 100 - 200 microns dry (167 - 333 microns wet) may be specified depending upon end use

Theoretical Coverage: 4.8 m²/litre at 125 microns dft, allow appropriate loss factors

Method of Application: Airless Spray, Brush, Roller

Flash Point (Typical): Part A 28°C; Part B 26°C; Mixed 28°C

Induction Period: Not required



Thinning is not normally required for Intershield 300.

If required use International GTA220.

Technical Data Sheet

bottom of page