top of page

Intershield 300

 

Product Description

A light coloured, abrasion resistant, aluminium pure epoxy coating giving excellent long term anticorrosive protection and low temperature application capability.

 

Intended Uses

A universal primer which can be applied directly to mechanically prepared shop primer or suitably prepared bare steel. Suitable for use with controlled cathodic protection.
For use at Newbuilding or Maintenance & Repair.

Product Information

Colour 

 ENA300-Bronze, ENA301-Aluminium 

 

Theoretical Coverage 

 4.8 m2/litre at 125 microns dft, allow appropriate loss factors 

 

Part B (Curing Agent) 

 ENA303

 

Volume Solids

 60% ±2% (ISO 3233:1998) 

 

Mix Ratio

 2.50 volume(s) Part A to 1 volume(s) Part B 

 

Typical Film Thickness 

 125 microns dry (208 microns wet). Range 100 - 200 microns dry (167 - 333 microns wet) may be specified depending upon end use. 

 

Method of Application 

 Airless Spray, Brush, Roller

 

Flash Point (Typical) 

 Part A 28°C; Part B 26°C; Mixed 28°C

Thinner

Use International GTA220. Thinning is not normally required. Consult the local representative for advice during application in extreme conditions. Do not thin more than allowed by local environmental legislation.

 

Technical Data Sheet

bottom of page